| 余绍蓉,杜强,李心耀,王军.TLJ-60A型土工离心机转臂系统力学分析与实测分析[J].装备环境工程,2015,12(5):40-44,49. YU Shao-rong,DU Qiang,LI Xin-yao,WANG Jun.Mechanical Analysis and Testing of Rotary Arm System of TLJ-60A Geotechnical Centrifuge[J].Equipment Environmental Engineering,2015,12(5):40-44,49. |
| TLJ-60A型土工离心机转臂系统力学分析与实测分析 |
| Mechanical Analysis and Testing of Rotary Arm System of TLJ-60A Geotechnical Centrifuge |
| 投稿时间：2015-07-24 修订日期：2015-10-10 |
| DOI：10.7643/issn.1672-9242.2015.05.006 |
| 中文关键词: 土工离心机 转臂 强度 数值模拟 试验 |
| 英文关键词:geotechnical centrifuge rotary arm strength numerical simulation test |
| 基金项目: |
|
|
|
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 目的 评估TLJ-60A型土工离心机转臂系统能否满足强度要求， 并提出改进建议。方法 对转臂系统建立三维有限元数值模型， 确定载荷条件和边界条件， 计算关键部位的最大等效应力， 给出材料使用建议。在建成后离心机运行中进行应变响应实测， 并就计算结果与实测数据进行比较分析。结果 数值模拟结果与实测结果吻合较好， 平均差异为4.5%， 最大差异为12.46%， 数值模拟偏保守。结论 评估结果及改进建议是正确的， 支撑了设备研制的一次成功。 |
| 英文摘要: |
| Objective To evaluate whether the rotary arm system of TLJ-60A geotechnical centrifuge can meet the strength requirement and give some suggestions. Methods The 3-dimensional finite element numerical model was built and the boundary and load conditions were determined. Then the maximum equivalent stresses in key locations of the rotary arm system were calculated and a suggestion on the material selection was given. After the centrifuge assembling, the strains of the corresponding locations were tested in a working condition. Results It showed that the numerical results agreed well with the test results. The mean difference was 4.5%, the maximum difference was 12.46%; and the numerical results were conservative. Conclusion The evaluation and the suggestions were correct, which supported the one-time success of the equipment. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
