| 牛宝良,陈洪.某离心机模型辨识与仿真[J].装备环境工程,2015,12(5):61-66. NIU Bao-liang,CHEN Hong.Model Identification and Simulation of a Centrifuge[J].Equipment Environmental Engineering,2015,12(5):61-66. |
| 某离心机模型辨识与仿真 |
| Model Identification and Simulation of a Centrifuge |
| 投稿时间：2015-07-30 修订日期：2015-10-10 |
| DOI：10.7643/issn.1672-9242.2015.05.010 |
| 中文关键词: 参数辨识 直流调速 仿真 离心机 环境试验 加速度试验 |
| 英文关键词:parameter identification DC speed regulation simulation centrifuge environmental test acceleration test |
| 基金项目: |
|
|
|
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 目的 辨识某离心机的加速度控制模型， 并开展控制系统仿真和优化。方法 实测某离心机运行时的转速、 电压、 电流等， 对保载和加速状态的电流进行拟合， 进而分析保载阻力、 等效转动惯量等模型参数。建立离心机加速度控制系统Simulink仿真模型， 进行仿真试验。结果 基于辨识的模型参数进行仿真的结果与真实系统试验的结果很接近， 为控制系统优化、 各种试验能力和误差预估提供了可信的模型。结论 采用的辨识方法可行， 辨识的参数正确， 离心机仿真模型运行快速正确， 可供相关离心机辨识和仿真参考。 |
| 英文摘要: |
| Objective To identify the acceleration control model of a centrifuge and to carry out the simulation and optimization of the control system. Methods The speed, voltage and current during the running of a centrifuge were measured, and the relationship between the armature current and the speed was fitted at speeding up and speed-hold states. Then the model parameters of load resistance and equivalent inertia were analyzed. The Simulink simulation model of the centrifuge acceleration control system was established. Results The simulation results of the model based on identified parameters were close to the results of the real system test, providing a credible model for the optimization of control system, estimation of various test ability and control error. Conclusion The identification method is feasible and the parameters are correct and the running of centrifuge simulation model is fast and correct, which can be used for the identification and simulation of the centrifuge. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
