| 袁猛,张幸,刘元海.海洋大气模拟环境下电连接器安装防护工艺验证分析[J].装备环境工程,2016,13(5):134-139. 袁猛,张幸,刘元海.Validation and Analysis about Installation and Protection Technology of Electrical Connector under Simulated Marine Environment[J].Equipment Environmental Engineering,2016,13(5):134-139. |
| 海洋大气模拟环境下电连接器安装防护工艺验证分析 |
| Validation and Analysis about Installation and Protection Technology of Electrical Connector under Simulated Marine Environment |
| 投稿时间：2016-03-09 修订日期：2016-03-15 |
| DOI：10.7643/ issn.1672-9242.2016.05.022 |
| 中文关键词: 电连接器 海洋环境 安装防护 |
| 英文关键词:electrical connector Marine Environment installation and protection |
| 基金项目: |
|
|
|
|
| 摘要点击次数: |
| 全文下载次数: |
| 中文摘要: |
| 目的研究海洋大气模拟环境下,电连接器不同安装防护工艺方法的环境适应性。方法选取有代表性电连接器,以不同的安装防护工艺装配在典型结构材料制作的安装板上,在实验室加速腐蚀环境下,验证其不同的防护效果。结果电连接器线缆的不同防护工艺将对电连接器基本电性能造成直接影响,安装板与电连接器接触面的防护工艺不同将对其基体材料的腐蚀程度造成很大差异。结论采用热缩管对连接器线缆进行有效的密封能保护电连接器内部结构,避免腐蚀介质的侵蚀对电性能造成影响,电连接器安装(包括方盘安装和气密螺母安装),应对其安装接触面进行填角密封,且安装板前后两面都需要进行密封。 |
| 英文摘要: |
| Objective Research the Environmental adaptability of different installation and protection technology for electrical connector In the ocean atmosphere simulation environment。Methods Selecting some representative electrical connector to be assembled on the mounting plate of the typical structure material with different installation protection technology, and then testing and verifying the different protective effect in the laboratory accelerated corrosion environment. Results Different protection technology of electric connector cable will affect the basic electrical properties of electrical connector directly. The difference protection technology of the contact surface between the mounting plate and the electric connector will cause a great difference in the degree of corrosion. Conclusion using heat shrink tube to sealing electrical connector cable can protect internal structure of electrical connector an avoid reducing electrical properties from the damage of corrosive medium, Electrical connector installation (including square installation and tight nut installation) should seal the gap at the edge of the contact surface, And ensure that both of the before and after sides of mounting plate are sealed well. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
| 关闭 |
