马平昌,刘玥,高飞,芮鹏,崔英伟,路梓照.基于散流器的盐雾箱饱和加湿技术研究[J].装备环境工程,2023,20(8):160-164. MA Ping-chang,LIU Yue,GAO Fei,RUI Peng,CUI Ying-wei,LU Zi-zhao.Saturation Humidification Technology for Salt Tank Based on Diffuser[J].Equipment Environmental Engineering,2023,20(8):160-164.
基于散流器的盐雾箱饱和加湿技术研究
Saturation Humidification Technology for Salt Tank Based on Diffuser
投稿时间:2022-11-10  修订日期:2023-01-04
DOI:10.7643/issn.1672-9242.2023.08.021
中文关键词:  盐雾试验  溶液浓度稳定  饱和加湿桶  湿热加热  散流器  气水分离器中图分类号:TH69  TG174.3+7 文献标识码:A 文章编号:1672-9242(2023)08-0160-05
英文关键词:salt spray test  stability of salt solution concentration  saturated barrel  wet heating  diffuser  gas water separator
基金项目:
作者单位
马平昌 北京强度环境研究所,北京 100076 
刘玥 北京强度环境研究所,北京 100076 
高飞 北京强度环境研究所,北京 100076 
芮鹏 北京强度环境研究所,北京 100076 
崔英伟 天津航天瑞莱科技有限公司北京分部,北京 101102 
路梓照 天津航天瑞莱科技有限公司北京分部,北京 101102 
AuthorInstitution
MA Ping-chang Beijing Institute of Structure and Environment Engineering, Beijing 100076, China 
LIU Yue Beijing Institute of Structure and Environment Engineering, Beijing 100076, China 
GAO Fei Beijing Institute of Structure and Environment Engineering, Beijing 100076, China 
RUI Peng Beijing Institute of Structure and Environment Engineering, Beijing 100076, China 
CUI Ying-wei Tianjin Aerospace Reliability Technology Co., Ltd., Beijing Branch, Beijing 101102, China 
LU Zi-zhao Tianjin Aerospace Reliability Technology Co., Ltd., Beijing Branch, Beijing 101102, China 
摘要点击次数:
全文下载次数:
中文摘要:
      目的 提升盐雾箱饱和加湿桶湿式加热性能,保证盐雾试验过程沉降盐雾溶液浓度的稳定,进行盐雾试验箱饱和加湿桶的设计与研究。方法 对饱和加湿桶压缩空气入口和出口进行结构设计,入口采用散流器实现湿式加热,出口设置气水分离器,对出口气流进行气水分离,从而形成较为“洁净”的饱和湿空气。对饱和加湿桶进行性能测试,验证盐雾试验箱饱和加湿方法的有效性。结果 散流器可以使气流在水中形成稳定的流动,有效抑制气流直通液面的浪涌现象,避免液滴飞溅产生,并增大了压缩空气与去离子水的接触面积。供气压力为50~150 kPa时,饱和加湿桶出口气流的相对湿度在不同温度下均可达到83%~90%,且试验过程出口流道无明水喷射。结论 通过对饱和加湿桶的设计,有效提升了湿式加热的效率,并形成较为“洁净”的饱和湿空气,满足盐雾试验要求。
英文摘要:
      The work aims to carry out the design and research of the saturated barrel in salt tank in order to improve the wet heating performance of the saturated barrel in salt tank and ensure the stability of the salt solution concentration during salt fog deposition process in salt spray test. The structure of the compressed air inlet and outlet of the saturated barrel was designed. The diffuser was used at the inlet to improve wet heating efficiency, and the gas water separator was set at the outlet to separate the gas and water at the outlet, so as to form relatively "clean" saturated wet air. In order to verify the effectiveness of the saturation humidification method, the performance of the saturated barrel was tested. The test results showed that the diffuser could make the air flow in the water form a stable flow, effectively inhibit the surge of the air flow through the liquid surface, avoid the droplet splash and increase the contact area between compressed air and deionized water. When the air supply pressure was 50 kPa~150 kPa, the relative humidity of the air flow at the outlet of the saturated barrel could reach more than 83%~90% at different temperature, and there was no obvious water jet in the outlet channel during the test. Through the design of saturated barrel, the efficiency of wet heating is effectively improved, and the relatively ements of salt spray test.
查看全文  查看/发表评论  下载PDF阅读器
关闭

关于我们 | 联系我们 | 投诉建议 | 隐私保护 | 用户协议

您是第13563732位访问者    渝ICP备15012534号-5

版权所有:《装备环境工程》编辑部 2014 All Rights Reserved

邮编:400039     电话:023-68792835    Email: zbhjgc@163.com

视频号 公众号